Skip to content

Inputs

Analog Input Functions

Specifies the functions of analog inputs.

An asterisk indicates inputs with a pull-up

Air conditioner pressure sensor - See description of customizable outputs, Air Conditioning mode.

Switch calibrations - If the input voltage is above 2.5 volts, the calibrations set is changed.

Autostart - See description of customizable outputs, Autostart mode.

Boost Limit - A variable resistor is connected. Adjusts the boost level from minimum (0 volts) to maximum (5 volts)

Digital Input Functions

Specifies the functions of the pulse inputs for connecting VR or hall sensors.

Checkbox

Specifies the pulse edge for triggering the input.

  • Checked - front edge (transition from 0 to 1)
  • Unchecked - rear edge (transition from 1 to 0)

VVT1 / VVT2 angle sensor - Camshaft angle measurement mode.

Speed sensor - Connection of speed sensors. These sensors are measuring the speed of the wheels.

  • 1a - Left driven wheel
  • 1b - Right driven wheel
  • 2a - Left drive wheel or gearbox/diff sensor
  • 2b - Right drive wheel

If only one sensor is used (e.g. on gearbox/diff), it should be connected to the 1a input.

Buttons

The unit has up to 8 button inputs. Their number depends on the hardware version of the unit.

You specify the function of each button separately. If you set the same function to multiple buttons, only the button with the lowest index will be triggered.

Green Square

Indicates the presence of a voltage at the input.

Checkbox

Inverts button state

Switch calibrations - Switches calibration sets 1/2

Autostart - Activates Autostart sequence

Enable air conditioner - air conditioner compressor switching input

TCS off - Disables TCS with a long press. Button without locking. After restarting, the TCS will be enabled again.

Launch control - Activates manual launch control if no speed sensor is connected

Ignition retard - activates ignition retard feature

Brake, Clutch - pedal signals

Antilag - turns on/off the anti-lag system

AT on - automatic transmission drive signal for idle valve position correction. It's not needed, if you use internal AT control feature.

Marker - sets the marker signal in the log, to easily find particular point in the log file.

Methanol - activates methanol corrections

Selector ? - to connect the signals of the automatic transmission selector

AT sport mode - activates the sport mode of the automatic transmission