W4vyyy6 These pictures were taken at the same time temperature shows a lot higher on Ecu than on the gauge. Also air temp doesn’t go up a lot don’t know if this is correct. My temp sensor is a 1 pin sensor.
JHM 1pin sensor isn't accurate, so if water isn't boiling then everything is fine. You can make a custom CLT calibrations if you wish.
JHM W4vyyy6 Yes, you have to measure the actual data. I can give you table values from the inbuilt calibration which you're using
JHM Jetronic Preset: 3.94, 3.59, 3.16, 2.67, 2.16, 1.71, 1.31, 1.00, 0.75, 0.57, 0.43, 0.31, 0.25, 0.20, 0.16, 0.12