Invent-labs

Hi guys.
I have to write in englisch, because i'm from germany and can't speak russian.
Just wanted to install the invent jetronic kit, but theres no manual for Installation specific at a audi 80 ACE.
For now, i need a guide for adjusting the ignition Distributor. It is different to that one from the NG and Also from the one in Audi 100 ACE
Could someone explain to me, how i could find the correct window and on which side i have to cut the 1,1mm?

Tanks for your help

Hi, check this short guide

Mark case next to 1-st cylinder spark cable

Remove distributor cap and turn crankshaft to align rotor with your mark

Remove distributor. Keep rotor aligned to mark

Mark distributor vane, which is at the center of the hall sensor. This vane should be cut by 1.1mm

Do not forget, on the ACE motor the rotor rotates counterclockwise

I think it works.
How could i check, if its functioning?

punktwone wrote:I think it works.
How could i check, if its functioning?

Phase will lit green in Commander