JHM I reflashed the latest update, 4.0.17. I did upload old map files from the old forum; it kind of worked for me. But also, I tried from scratch, by uploading the given calibration, setting injectors to 107, and everything else, by following instructions, and also by watching a video that is filmed in Russian, but it still wouldn't work. For the first time, it's been almost 2–3 months since then. By following instructions, it did run but did not accept any throttle. I understand that the Idlle switch is critical, but all I need to do is change the full load because I connected to ext. The main issue at the moment is that when I set it up by instructions, it starts, reaches 500 RPM, and stalls. Or even sometimes, it's extremely hard to start. Also, when starting the engine, it feels like it grabs and then stops, but the ecu does not disconnect or something like that. I tried to replace the MAP sensor with a generic one from Honda Jazz, if I remember well, but it did exactly the same, so I don't believe the original map sensor is bad. In the MAP sensor, it does reach 5 volts and other signals, checked more than once. Also, I rechecked all pinouts, and they were all good.