Hello, I have a litte question about the Ignition Control.
I've installed the Kit in an Audi 100 C3 2.3 NF. Since now i didn't run Ignition Controll, so that the Stock ECU controls the Ignition. But i wanna run it with the Invent Ignition Control. And here comes my Question:
The EMUL Wire is now connected to the "KE Jetronic connector" to emulate the Signal for the Stock ECU (Picture 1)
In the Ignition Control manual, it says, that i have to connect this EMUL wire to the Ignition Amplifire.
But where exactly do i have to connect it?
And does the Connector, where it is now connected, stays alone?
Thank you very much.
