i have a few questions about the setting options in the software.
Under ignition,other, base settings what is dwell time and octane corrector? can i use octane to add angle when i fill up with super plus?
what do I set in the table angel corecction by Charge T? should it be Air T?
what can idle stabilization do?
what is dynamics?
What is a smoothing of 5? What if I make it 1 or 10?
what is accel correction? what does it do if I go to 5?
What is meant by injection, correction, air charge heat soak?
what are the values of 0-352?
i assume that i set injection timing in the table but in relation to what?
what are the fuel charge T and fuel charge T correction?
there is no temperature sensor for the fuel so where does it get T (Temp) from?
under injection, transients, what is correction level? i think it should be rpm but what are the adjustable values?
what is the idle cutoff used for under parameters, idle? is the delay ms or sec?
I hope you understand what I am trying to indicate.
For many numbers the units or small pieces of information are missing. (e.g. T = °C or F ) are missing and so you can only find them out with try and error or not at all because they make too small a change.
Please change the things in a software update they are quality of live changes where many errors can be prevented.