Hi,
My project is a Mercedes 190e M102 engine.
I recently bought an Aem wideband with a Bosch LSU 4.9.
This type of wideband has a positive analog output of 0-5v and a negative analog output, which I understand has to go gnd.
Does the positive output have to be connected to the gray lambda cable and the negative output to the common negative?
To carry out the software programming I have to activate the wideband check and configure the probe as if it were a normal lambda. Should I do something else?
I am attaching the wideband manual in case it is necessary.
Thank you very much.
Best Regards.