Installation of 60-2 crankshaft position sensor on the Audi AAN/ABF engine

The Audi 2.2T AAN engine uses a crankshaft sensor system with two sensors on the flywheel and a hall sensor. Over time, this system begins to operate erratically at high speeds.

The Audi 2.0 16V ABF engine uses distributor with a hall sensor.

To easily install the 60-2 trigger system, you need to use the rear crankshaft oil seal from VAG 2.0 TDI engine, which has a built-in 60-2 trigger wheel (FEBI BILSTEIN 37746)

To position the pulley, set the engine to the 1st cylinder TDC, and use the following drawings.

  • 4 cylinders:

  • 5 cylinders: